Armattan Morphite 10 degree motors mounts

thingiverse

Here are 10 degree 1306 motor mounts for the Armattan Morphite: Use two for each motor mount; it's a little puzzle, but you'll figure it out. You will need to enlarge screw holes slightly, depending on your printer's accuracy in producing holes. I used a pin vise and reamer. To allow bolts to be at a 10 degree angle, you will need to enlarge the holes on your morphite frame. I used a needle file. These came out at 9.3mm on my printer. I used M2x12mm socket head bolts and washers. Be careful not to damage motors by using bolts that extend into the motor too much.