Armattan Gecko DJI FPV air unit mount

thingiverse

A mount to fit a DJI FPV air unit in an Armattan Gecko 3" without modifying the frame. Make sure your fc + esc are under 7mm, and you get 1.5mm of clearance between the air unit and the plastic connector plugs. You can raise the top plate with standoffs, but then you lose frame integrity. Fitting the camera in the gecko mount is also a pain and only works with the middle hole and a set angle; else you see the camera cage in your 16:9 feed. 1. Push camera through large hole in mount 2. Fit air unit in mount. Easiest to add antennas now, but you can fit them afterwards too 3. Slide top plate in and make sure notches line up 4. Make sure there is enough clearance and nothing is going to knock on your gyro 5. Use a long battery strap and wrap it round the whole thing. There's no space through the frame anymore, but a strap will secure the mount even better. Use landing gear below to get enough clearance for strap, nuts, and antenna. Landing gear with slot for zip tie to mount antenna: https://www.thingiverse.com/thing:4091796 Tail capacitor hammock and XT30 holder: https://www.thingiverse.com/thing:4091808 V7 is the pictured version V8 is a new one with thicker top cover to insulate and avoid extra battery pad, and I adjusted side plates to avoid knocking FC's usb port and plugs. Mudflaps is an unprinted experiment. It's V8 with larger side holes and 0.8mm flaps to protect usb port and sdcard