Armattan Gecko BetaFVP LED board Mount

thingiverse

printed out one of Kodiak1120's led boards for my Diatone gt-r349 rabbit. It worked great on my Armattan Gecko, so I thought I'd use it there too. My Gecko has a rear buzzer mount, which is where this new design fits snugly against, leaving just the right amount of space between the top plate and the hole for wires to pass through. This mount sticks up from the bottom of the quad and I swapped out the stock screws with some m8 screws. I printed it in petg, but I'd really like to try a tpu version - maybe one with a slot for the board to slide down into a groove. The vhb used to attach the board to the mount doesn't stick too well, so we'll see how that works out. For now, this one is doing just fine. On a side note, I broke the one on my Diatone and had to replace it. Instead of re-soldering the wires, I snipped a piece off the top bar to fit the wires through - and that worked great too. I went ahead and designed a new version with a tpu mount where the board slides in. After printing, there's just one tweak needed: the hole for the led's is a bit small, so I removed the v4 and added a v5. After crashing my Diatone again - ouch! - I realized that if the board points down on it, the battery will slide back and break the mount. So, I'm working on an improved version of that one right away.