Armattan Chameleon TPU

thingiverse

Armattan Chameleon TPU Remix - go ahead, remix it! My own design, feel free to take it apart and put it back together. I highly suggest printing this in TPU, it's designed to use two 35mm standoffs at the front for extra support. Get it downloaded now! I strongly recommend printing the hinge and arm protectors with 100% infill and the canopy itself between 20-40%. Don't forget to get these additional parts: * Two 35mm standoffs * Six 10mm screws * Four 12mm screws * Six nuts, all M3 Now, let's assemble this thing! It's pretty simple. Use two 35mm standoffs at the front for frame support, and melt two nuts onto the hinge assembly as shown in the pictures above. Next, use four 10mm screws to secure the front standoffs. Then, use two 10mm screws and two nuts on the rear holes of the hinge. Be careful not to overdo it - the canopy won't lift freely if you go too long. Finally, use two 12mm screws to mount the canopy to the hinge. And don't forget to secure the battery pigtail with a wire pin! Use two 12mm screws and two nuts to hold it in place. I recommend using the wire pin as a template and cutting one from carbon for extra strength - it's worth the extra effort!