Armattan Acro Pod Hawkeye VTX Mount

thingiverse

I made this mount to fit snugly in the notches at the back edge of my Armattan Acro pod. The slots are designed to securely hold a carbon plate and the LED array that comes with it. I was using a Kiss FC, which doesn't support programmable LEDs, so I decided to create something to fit this need instead. Print both files, it's two parts in total. The back has a groove for the SMA pigtail and a hole at the bottom for wires, making it easy to route them out of the way. This mount gives clean access to dip switches, allowing for quick adjustments on the fly. The pigtail end goes up, and the pigtail can be looped through the small hole to the left, then straight down, and finally mounted in the SMA bulkheads behind the pod. I prefer to remove the connectors on my VTX and solder directly, but I haven't tested it with the connector still attached, so I'm not sure if it will fit. That's why the hole for wires is placed all the way to one side. Updated version available at http://www.thingiverse.com/thing:1481715 Print Settings: Printer Brand: MakerGear Printer: M2 Rafts: Doesn't Matter Infill: 35% Notes: Use supports for the tabs and the biggest curve