Arduino Uno Snug Case

prusaprinters

<p>This is my remix Esquilo's Arduino case.</p> <p>I think the intention behind the original design was to create a smart looking case to house a finished project.</p> <p>My remix isn't as pretty as it is intended to be a permanent home for my prototyping Arduino with the greater emphasis on ease of use. The main difference being that holes in the lid are bigger allowing a view of the pin label, printed on the circuit board.</p> <p>Other Modification:</p> <ol> <li><p>Some supports on the lid hole the Arduino secure without the need for screws.</p> </li> <li><p>Most of the lid has been made thinner so it can act as window... sort of :), if made of transparent material.</p> </li> <li><p>Added two more clips at front and back to hold lid secure.</p> </li> <li><p>Hole to reset button is larger fore easy access.</p> </li> </ol> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Ultimaker</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ultimaker 2</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.4 nozzle __ 0.2 mm layer thickness</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> <p><strong>Notes:</strong></p> <p>top &amp; bottom shell thickness was set to 0.8mm. if u set it lower u might get infill rather than a solid window on the lid.</p> </p></p></p> Category: Electronics