Arduino Uno + Large breadboard holder (2 versions: With nubs and With M3 screw holes)

thingiverse

I noticed a few of these holders for Arduino Unos together with breadboards but none were what I was looking for. Most were designed for smaller breadboards and the couple that were for large ones were pretty stripped-down which is good for not using too much filament but also arent comfortable to hold in my hand and I sometimes prefer to fiddle around with stuff while holding it rather than having it on a desk. Therefore this holder deliberately has a large surface underneath the board and has tighter fittings, which should hold both the breadboard and the arduino. The ones Ive printed out can hold the boards even if it is upside down (nubs version), although depending on the printing the tolerances can be off, so do this at your own risk. There are 2 versions, one has little nubs that correspond with the screw holes on the Arduino board, another has holes going through the holder Feedback is appreciated, also if anyone has an idea why Solidworks exports STLs rotated 90° to one side, let me know. Donation addresses: Nano : nano_3t8zhi1yncd6sj36j8iakoug3nt7xs37obkytupt6bb35os458uxnpjbrwja Bitcoin : 3MhH8vC7q6pX1pTjKsAyJsTr8Tr4o6VcLJ Ethereum : 0xdB76DcECf881A0E9bdbc047d351a54f743AB4F02 Dash : XcGwvVZZ2BrXPjckPtdbM3SzLU2hPZrTTu Litecoin : MCCGrYmwseosSd36zYU4YS3VZyJHT1iYLJ