Arduino Nano Breakout

thingiverse

Arduino Nano breakout box and lid. Mount this box to a din rail at http://www.thingiverse.com/thing:1688532. Cut the walls off of the box to make a tray, then cut the mounts too. Place some rubber feet under this tray and you can put a breakout board in it to sit on your workbench or desk without fear of the solder lugs underneath shorting or touching something bad. Revision: Remix my breakout box a little by removing the 2 oval holes. This box is still 30mm's tall, but I made a shorter version also, 20mm's tall with wiring cut outs. The lid remains the same, as does the tray. Except for adding holes to screw down the breakout board and din rail brackets, which I did for all three. I also remixed 60x40-PerfBoardMount thing:2761904 by ValarmLLC a little, removing the original mounting tabs and adding my din rail mount tabs.