Arduino Nano 33 Holder

thingiverse

A nice little holder/sleeve for Arduino nanos. Designed specifically for the Arduino Nano 33 BLE, but it fits all of them with that form factor: Sense, IOT, etc. It's just a little extra protection and something to hold on to for those not using the pins on the board. I have a patch of velcro tape on the bottom of mine to attach to my gaming headset for single board headtracking (once it's tested I'll drop the repo link here so you can use that too). Infill doesn't matter, so thin it's basically 100 no matter what because it's all walls. Make sure to use a brim and a pretty wide one (print vertically too btw). I have used PETG and PLA with no issues. If your printer is very accurate don't change anything about the model, it's a nice fit that is not too stiff but could slide out if you really whip it around. I printed and then used the paper from the arduino manual to shim it so it will be extremely hard to remove. If you have shrinkage or accuracy problems I might print at 101% scale or even bigger just to be safe but no worries if it comes out bad, barely uses any plastic.