Arduino Leonardo slim case with mounting tabs

thingiverse

Just finished adding some mounting tabs to this fantastic project. I discovered that the studs going through the holes in the Leonardo PCB were just a hair too tight, so I carefully trimmed them down by a fraction to get a snug fit all around. Also, there's a large decoupling capacitor behind the power connector blocking the lid from closing properly due to the "cut-out walls" surrounding the analog pin connector. If I were to print this again, I'd make some adjustments to the design by shaving 0.2mm off the PSB support studs and creating a cutout for that massive capacitor. Apart from that, this is an excellent design from the original creator, huge kudos! Love the tiny reset button. Prints with no supports, used standard settings on my Ultimaker 2+.