Arduino LED Watch

thingiverse

I designed an Arduino LED watch enclosure that can be printed in one piece and assembled as needed. The complete watch fits wrists up to 7 inches in circumference. You can print all parts individually and snap them together. The clasp is a hook and loop design that may require some sanding for proper closure, depending on your print settings. I'm open to suggestions for improvement. I initially used tinted plastic for the top plate but you can also use transparent filament. The plate is press fit into place without screws. You can add white glue if desired, but avoid superglue in case disassembly is needed later. Attach buttons to the inside of the watch body using a small amount of superglue.