Arduino Dev Board Power Panel

thingiverse

This is my first 3D printed project that I have shared. I made this to hold two switches on my Arduino development platform. I needed isolation switches to cut power to the arduino and to the external peripherals as needed. This board requires two screw holes at the top that will allow you to mount it to your power supply, but since I didn't want to limit you to the same power supply I use, I didn't include the holes. I recommend you drill them as needed. Or, you could just use double-sided foam tape if you choose. At first I didn't have the little support, but I lost a few prints due to the item popping off of the platform during the print, so I added the little leg. Just cut it off after the print is complete. It'll leave a mark on the back of the panel but you won't see it.