Arduboy replacement face/back plate

thingiverse

Arduboy Replacement Face Plate This is a replacement part for Arduboy's face-plate. Arduboy: https://arduboy.com/ Please make it with the original back plate, screws, and buttons. Transparent/translucent filaments are recommended. Examples of output shown in the attached picture are "t-glase" and "PLA". (t-glase blue / PLA-translucent-green / PLA-transparent / PLA-translucent-red / PLA-translucent-pink) The screw assembled to Arduboy is not a tap screw. Please try so that it can be screwed into the hole as shown in the attached picture. And be careful not to overtighten it. *** 9/06/2018 : Update *** Addition of casing parts for Mr. Blinky's Flash Programmer (ISP). CAD file: case_113_btcn020.stp (case_113_btcn020.123dx) STL file: case113_btcn020_bkp.stl, case113_btcn020_cnc.stl Requirement: Piece of universal board(t=1.5 or 1.6mm) --> for 15x32mm universal board. Female header --> 12 pin, width=31.5mm. Cut end of flat cable or 10 wires, about 35mm long. 4pcs. of "M2, 5 mm tapping screws" are required. *** 9/06/2018 : Update *** Addition of casing parts for Mr. Blinky's Flash Programmer (ISP) with I2C, TX & RX connector. CAD file: case_113_btcn021.stp (case_113_btcn021.123dx) STL file: case113_btcn021_bkp.stl, case113_btcn021_cnc.stl Requirement: Piece of universal board(t=1.5 or 1.6mm) --> for 15x32mm universal board. Female header --> 12 pin, width=31.5mm. Cut end of flat cable or 10 wires, about 35mm long. 4pcs. of "M2, 5 mm tapping screws" are required. *** 9/06/2018 : Update *** Addition of casing parts for Mr. Blinky's Flash Programmer (ISP) with SPI, I2C, TX & RX connector. CAD file: case_113_btcn022.stp (case_113_btcn022.123dx) STL file: case113_btcn022_bkp.stl, case113_btcn022_cnc.stl Requirement: Piece of universal board(t=1.5 or 1.6mm) --> for 15x32mm universal board. Female header --> 12 pin, width=31.5mm. Cut end of flat cable or 10 wires, about 35mm long. 4pcs. of "M2, 5 mm tapping screws" are required. I am very grateful to Mr.Blinky, crait, MLXXXp, Keyboard_Camper, filmote, Pharap, eried, Pygasm, bateske and all of Arduboy's community. Thanks for much advice and suggestions.