ArcVase1-update

thingiverse

I employed curved lines to construct the fundamental form of this component. The images depict the STL file SCALED DOWN TO 50% BEFORE PRINTING because printing the full-size model would have taken approximately two days. This print took around eleven hours and fifteen minutes using a print speed of 90 mm/sec and a layer height of 0.200 mm. I'll upload additional photos of the full-size print once it's completed. Two days later: I've attached two photographs of the full-size print alongside the 50% scaled-down model. The full-size print took forty-four hours and twenty-one minutes to complete, so most individuals will likely prefer a smaller size. However, scaling it down works surprisingly well.