Architect Lamp - Table Clamp

prusaprinters

<p>I designed this base Table Clamp for renovation of an old Architect Lamp. The model will work with most Architect lamps.</p><p>The bolt used is a standard metric M8 x 60mm full threaded and standard M8 nut.</p><p><strong>Tip:</strong><br>As the gripping surfaces are smooth to avoid making marks when the holder is clamped on a soft surface like pine, the holder can slip on hard smooth surfaces. To avoid this, it is useful to place/glue rubber, felt or cork to the gripping surfaces.<br>This is also what I use, even on the original metal holders.</p><p><strong>Have fun…</strong></p><p><i><strong>&gt;&gt; If you like it, please leave a like, a make or maybe a rate… :)</strong></i></p><h3>Print instructions</h3><p>Printed without support and use right off the print bed.<br>There are no <i>sharp edges</i> for safety.</p><p>Suggested material is PETG.<br>Use 3 perimeters, a layer height of 0.20mm, 4 top and 3 bottom layers.</p><p>15-20% infill will make a strong part and using semi-transparent material will make the infill pattern visible (recommend Gyroid infill).</p><p>Shown model is printed in Devil Design Ruby Red PETG.</p>