Arcane style mechanical butterfly

cults3d

Mechanical butterfly inspired by those that can be seen in the great festival of progress in Arcane ,it is only inspired and not identical . The butterfly is printable in filament but also in resin if desired ,it prints correctly if you respected the printing instructions. You will need to provide glue, a cutter or a precision blade and finally brass wire for the antennas. PRINTING INSTRUCTIONS: Wings simply print flat, being careful to put the large wing pattern up. The bust prints head up ,no support is needed ,no raft either. For the abdomen it must be printed flat to not have a printing defect and it is important to put supports at 60 ° but the raft is optional. To finish, it is important to think of rotating the legs in the right direction as on the photo if above and add support to 60 ° and a raft for the proper conduct of printing. After printing you just need to glue the bust and abdomen flat so that they position well together. There may be some touching up to do on the small legs of the wings so that they fit properly in the bust but then the ideal is to glue them at the same time on each side by interlocking . Then adjust the holes for the legs with the cutting pliers or the blade so that they fit correctly then put a dot of glue. And to finish, heat 2 small brass wires previously cut to the desired length for the antennas and fix them on the top of the butterfly head, I advise you to put a dot of glue to solidify the whole on the joint between the antennas and the upper part of the head. I hope this nice print will decorate your home as it should ;-)