Arcade Skull Power Cord Support

thingiverse

I designed a power cord holder for my tabletop arcade cabinet after realizing the pre-cut hold for the power supply was only 2 inches. Since I couldn't find a suitable power switch, I created a custom solution. The skull splits in half at the jaw, allowing the sleeves to fit snugly into any 2-inch hole. A small 1/2-inch hole accommodates the power strip's cord size. To add extra security, I drilled tiny 1/8-inch holes in the skull for screwing it onto the cabinet if needed. However, everything fits perfectly now, and after painting both the cabinet and skull, I'm not sure if screws will even be necessary. Printer Settings: Printer: AiO 1.0 Da Vinci Rafts: None Supports: None Resolution: High-Quality Infill: Twenty Percent