AR Wing Twin Motor Mount

thingiverse

I designed a motor mount for a Sonicmodel AR Wing Pro. This is for a twin tractor setup with props up to 7 in. There is a little ESC bay underneath. A cooling channel leads fresh air to the ESC. The cabels from the ESC to the motor can be installd in this channel as well. The wires from FC/battery can run through another channel to the ESC. So, the setup is be pretty clean. I printed the motor mount vertically with the motor mount surface down as shown in the picture. The hatch I printed sitting flat (not as shown in the picture). I get the best result this way. Please melt some M2 or M2.5 theads to close the ESC hatch. The last picture shows the "evolution" of this motor mount. ;-)