AR Wing / RMRC Recruit LED Bar

thingiverse

Loved the sleek design and the LED bar that lit up the entire setup, but wished for a more streamlined wire layout. My wiring scheme goes like this: - The signal wire runs all the way to the far end of the right LED, with the solder point connected to the center of the board. - Power and GND wires are routed to either the inside + or - pad on each board and then bridged between the two boards' pads for a secure connection. To minimize clutter, I run the signal wire through the small slit in the center of the board. The LED boards are secured to the mount using double-sided tape for easy installation. There are pre-drilled counter-sunk screw points on each board if you prefer to use screws for mounting to the wing. Alternatively, a bead of hot glue or additional double-sided tape can also secure the boards in place.