AR Drone 2.0 center Cross

thingiverse

Human: English New!!! Now is the central axis available in version V3. A simple assembly and replacement are facilitated by two halves. For additional stability, the four stabilizers are attached to the four ends. There are eight screws with M3 thread and eight matching nuts needed to connect everything together. It was designed for 6mm aluminum tubes so you don't have to buy a completely new axis in case of a breakdown. It needs only the carbon tubes removed and replaced by 135mm long 6mm thick aluminum pipes. Then, simply take the cables out of the connectors and first pull them completely out of the tube. Then, drill the old motor holder to 6mm. Simply plug the aluminum tubes into the holes and glue if necessary. Well, and this is very important: push the stabilizers onto the pipe. The cable plug goes back into the circuit through the tube and it's assembled.