Aquila 3D Camera and Raspberry PI stand

thingiverse

Simple holder for RPI camera and boxed RPI on the bottom of it. The idea is to mount it using the front knob. You can use a thin washer if you like. I tested it with some generic camera and works very well. I didn't need to do anything else, but to carefully set the camera to the right angle (not fully pressed). It's not the most elegant or customizable solution, but works for me. It will definitely need support, but if you print with the front flat side down (mount hole up) you will have less troubles removing it Please set support overlapping angle to something like 80, to remove the support from most of the holes.