Aquarium Skimmer 12/16 hoose + 16/22 adapter

thingiverse

Not all 3D printed parts are shown at the screenshot section in Blue 3D viewer. PLA - Bed: 60; Hot Tip: 200 Infill: 20%; Wall Count: 5x (all directions) Some components require supports and rafts. The Skimmer telo requires no supports due to its thread custom support at the L part. The Skimmer hlava needs to be printed upside down with a raft, or at a speed of 50% because of small parts on the first layers after 100%. The Skimmer tyčka / Skimmer tyčka kratka require no supports; however, the smaller middle part is designed for stronger filters, and the larger one is for weaker ones. The Skimmer tyčka pridavny kruzok is an add-on part that restricts the middle part if insufficient suction is obtained from the upper Skimmer part. The Holder for Skimmer consists of 5 parts: 3 of which can be printed twice to create 2x Skimmer uchyt and 1x Skimmer tyčka drziak. Additionally, you will need an Eheim suction cup (2x). The Adapter 16/22 has not been tested; it may require gluing and sanding to fit the body of the skimmer. If you need an adapter for your hose, please comment below with your measurements in millimeters from 12.20mm onwards. I hope this information is helpful. Thank you for downloading, sharing, liking, remixing, and supporting my design journey by tipping the designer.