Aquacopter 5 inch

thingiverse

I have providet the full body and the already cut one i have so far only printed the cut one. Use with 30.5mm electronics and 16X16 motormounts you will have to drill the holes for the cables yourself i will add more pictures once my first prototype is finished. If you want to use a capacitor you will have to attec it with wires. I am using a 1500mah zop power 4s battery and a full sized camera. The lit is goint to seal using silicone as a seal you will have to put silicone on the lid and some sort of seperation material (pp tape for example) on the frame all the 4.5mm holes are intendet to have brass threated inserts seated(https://www.amazon.de/gp/product/B07KGB28TD/ref=ppx_yo_dt_b_asin_image_o01_s00?ie=UTF8&psc=1) you will have to cover the bottom of the insert with a worm screw to prefent plastic from going inside the threats if you fin the holes to tight you can also drill the open a bit. i suggest you print the addet pull test file and try you inserts in it it also has a 4.5mm hole. Your printer will need to be able to print at least 240X240mm or you will have to split the frame again. The plate goes over the electronics mounted on the 6 standoffs it seperats the battery from the elecetronics. The bottom cap will need to be printed 4 times and is used to seal off the bottom of the motors the chamber the motor connects to is not connected to the inside of the frame to prevent water from going in the frame throug the motor the caps are made with a lot of play so they can be printed on even poorly calibrated printers. If you notice any issues or have suggestions for the further development ogf the design let me know. Update: i edited the cap to fit with even more toleranz to account for the bad sirface from using support