Aqara Motiton wall screw-mount

thingiverse

Designed to hold the Aqara motion sensor swivel bracket firmly to the wall in a removable way. If you don't remove the sticky backing you can also loosen the screw slightly to rotate the mount after putting it up to get the sensor aimed optimally. This is designed to fit a #6 screw, but a #8 may also work. I recommend a "flat" style head (the ones that are reverse-cone shaped) so that as you tighten the screw it not only holds it to the wall but also securely clamps the motion sensor from rotating in the 3D printed mount. Do not over-tighten as it may damage the 3D printed part or sensor-mounting bracket. To assemble, hook the bottom edge of the Aqara mounting bracket into the bottom lip of the 3D print, then rotate it flat into the 3D print. It should fit firmly without much slop but without excessive force. Then, insert the screw so that the head of the screw just barely catches the lip of the Aqara mounting bracket. As you tighten the screw, it should pull the mounting bracket snugly into the print until it is firmly held without easy movement.