Aqara Motion Sensor P1 Holder / Case

thingiverse

The case for the Aqara Motion Sensor P1 can be used to mount the sensor to a wall using screws. The holes at the top and bottom can be used to put a square screw nut into it. You are flexible to decide between both. Simply drill a hole for the screw into the case. I designed this piece because I wanted to mount the Aqara Motion Sensor P1 to the roof. For flexibility I decided to use 1/4" screw nuts so that I am able to use the whole range of camera and photo equipment mounts available out there (tripods etc.). To mount the case to the roof I bought a pack of 3 mounts for the "Arlo Pro" surveilance camera from Amazon. I can use these to perfectly adjust the motion sensor, too. This is the mount I used: [Wasserstein Verstellbare Sicherheits-Wandhalterung für Arlo Pro, Arlo Pro 2, Arlo Pro 3, Arlo Pro 4, Arlo Ultra, Arlo Ultra 2 und andere kompatible Modelle (3er Pack, schwarz)](https://amzn.eu/d/fwd41hL) / [Backup at archive.org](https://web.archive.org/web/20230221163937/https://www.amazon.de/dp/B073XLQXTY) This is the screw nut I used: [1/4 Zoll - 20 UNC Vierkantmutter Stahl verzinkt Grade 2](https://www.zollshop.de/de/Zollmuttern-Scheiben-Federringe/Zollmuttern-UNC-UNF/Muttern-14-Zoll/14-Zoll-UNC/3489/1/4-Zoll-20-UNC-Vierkantmutter-Stahl-verzinkt-Grade-2/?number=732028) / [Backup at archive.org](https://web.archive.org/web/20230221163801/https://www.zollshop.de/de/Zollmuttern-Scheiben-Federringe/Zollmuttern-UNC-UNF/Muttern-14-Zoll/14-Zoll-UNC/3489/1/4-Zoll-20-UNC-Vierkantmutter-Stahl-verzinkt-Grade-2/?number=732028) **Possible improvements**: The screw nut and the case are very tight and I really had to force the screw nut into place. Also it is a little bit to high for the hole. So the size of the hole could be a little bit increased in a 2nd revision. It is also quite hard to get the sensor out of the case after it has been placed inside.