Aqara Door Sensor Magnet Cap

prusaprinters

<p>This is the cap for the magnet side of an Aqara Door sensor, I had one mounted on a sliding door too close and it got obliterated by the sliding door closing unfortunately so I measured up another one I had to replace it.</p><p>Its not exactly the same but it holds the magnet in place and fits well on the existing mount so I'm good with it. A few of the fine details were impossible to measure with my calipers so I sort of eyeballed them but like I said it seems to work well.&nbsp;</p><p>&nbsp;</p><p>In my case the magnet fell on to the floor and rolled away to whatever void things that fall on the floor go to so I had to order myself a replacement. It takes a 6mm diameter magnet thats 20mm in length. You can get that exact size on AliExpress but I wanted something quicker so I found some 6mm diameter magnets on Amazon that were only like 4mm thick but I just stacked them together. So either option works.&nbsp;</p><p>&nbsp;</p><p>Some of the details on this are pretty teeny tiny so you'll probably need one of those newfangled slicers with Arachne if you are using a 0.4mm nozzle, I bet it would also work great on a resin printer but I don't have one so can't verify.&nbsp;</p><p>&nbsp;</p><p>Sliced it 0.2mm with no supports and the infill doesn't matter since there isn't room for any.&nbsp;</p><p>&nbsp;</p><p>The line towards the bottom of the print in the first photo isn't present on the model, my printer just had some form of heated gamer moment and just did that.&nbsp;</p>