April 28 Domonic, Joey

thingiverse

Created by Customizer! To build this design, you will need to make use of the following options: - The thickness of each part comes out at a steady 6 - Hubs will be exactly 19.5 across when measured through their center point - All blades can stretch as long as you'd like but the first will always land at 6 slots long - If desired, you can also have a outer ring with thickness that amounts to about one whole unit added on - This feature gives room for adding your choice of size by adjusting od which is initially set at an even 158 units - For blade functionality we need the ability to control the width they open to so all will start off exactly 11.25 units apart - An angle in degrees has been selected specifically to help our cut feel sharp like a knife -25 on down - Each cut has to have the right height so 2 should do just fine for us here - The first point we place as this design is placed gets its orientation and it's easy to set at any number but let's go with an offset of about 90