Apple Watch Stand -Thing by MikeVR - Split

thingiverse

Here's a revised version of MikeVR's Apple Watch Stand - Thing split into two parts so smaller printers can fit it. The design has not been tested yet and pictures will be uploaded once that happens. If everything goes according to plan, the pegs should align perfectly, making gluing much easier. Unfortunately, STL files may need some repairs using a splicer. Edit 1 - I've finally printed the thing and it worked as expected! I might experiment with tightening up the peg tolerance a bit more. Right now, the hole is about 1.5mm bigger than necessary, but it still works just fine. I also plan to relocate the seam from its current position near the middle mark. This should allow the design to work seamlessly with most medium-sized printers.