Apple Watch Stand

thingiverse

This stand supports most Apple Watch widths, featuring a sliding book-shaped support member for adjustable fit. The design motif is inspired by Dharma's aesthetic. For optimal use with an 8mm-depth charger, this stand is designed. However, there are two types of chargers: one comes with the watch and has 8mm depth; another optional accessory has 6.6mm depth and requires a spacer like paper for adjustment. To secure the stand, I created 8mm nut holes in the bottom that can be used to add weight. The recommended print material is ABS, but PLA might be a better choice due to its durability. No support is needed during printing. After printing, you should flatten the stand's bottom with sandpaper for added stability. Use an M4 CAP screw to secure the sliding support member, preferably 10mm long. For bottom bolts, use M8 x 50mm screws, but be prepared to tap in the thread if necessary. It's a good idea to attach sponge rubber or similar material to the support member's surface to prevent damage to your Apple Watch. To set up the charger: 1. Insert the USB connector through the stand's face hole. 2. With the cable down, push the charger body into the stand face. 3. Push the cable into the groove on the bottom of the stand. 4. Attach the support member with an M4 cap screw and adjust its height to match your Apple Watch. To remove the charger: 1. Insert a pen from the bottom and press the charger gently.