Apple Magic Keyboard Angler

thingiverse

I wanted a slight tilt on my Apple Magic Keyboard, so I created this design and secured it with hot glue. Additionally, I added some grippy rubber to the base to prevent it from sliding around. The angle provided by this print is spot-on for my keyboard. Simply print two of them and space them far enough apart to support the keyboard. After using my keyboard with these supports for many months, they remain in perfect condition. This design is also very straightforward to print. The angle shown in the image appears steeper than it actually is; this design's length is just over half the top-to-bottom measurement of the keyboard. It only elevates the back of the keyboard by about 14mm.