Apple Keyboard - no slide/lift

thingiverse

I observed that all the apple keyboard device holders were lifting the keyboard up off the table, resulting in the keyboard's rubber backing failing to prevent the keyboard from sliding excessively.\nSo my model attaches on the side, preventing the keyboard from being lifted and allowing its rubber backing to maintain contact with the tabletop without slipping.\nThe screw enables the two hooks to switch sides: above the keyboard or to the side, giving space for charging the phone.\nPrint Settings\nPrinter:\n Duplicator I3 V2\n \n Rafts:\n No\n \n Supports:\n No\n \n Resolution:\n .2\n \n Infill:\n 20\n \n Notes:\n If print settings are too hot, the screw may stick and sink during printing. This can cause one side to be tight while the other is loose. A blow dryer can be used to heat the screw when tightening or loosening it for a smoother process.