Apple Iphone SE 2 Bicycle Stem Mount

prusaprinters

I saw some "easy to print" bicycle phone mounts and really liked the concepts, but I did not find any for the second generation iphone SE and I also wanted some minor changes, so I designed my own. This holder attaches to the stem on your bike with two zip ties. The holder is designed for iphones with a thin cover (mine is a 1mm thick silicone design). It latches into the bottom and the top holder snaps in. Takes a bit of force to open the latch, but I've removed mine about 200 times so far and it still works fine. Use a rubber piece (cut from an inner tube for example) to increase friction on the stem and protect the surface. May have difficulty fitting it on very short stems, mine is a 50 mm but on some of my mountain bikes I have 35 mm stems and it doesn't fit there. Print 1x vertical and 2x horizontal. I used 5mm wide zip ties. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.3 Infill: 30% Filament: Prusa PETG Black Notes: I printed this with 3 perimeters and 30% cubic infill at .3 mm layer height. Makes it strong and flexible. I would recommend using PETG as PLA isn't sturdy enough. Print time is about 1.5 hours. How I Designed This =================== Designed in SolidWorks 2019. I always get the 3D models for phones from www.grabcad.com, they are normally very accurate. To get the silicone cover, I added a surface offset to the phone housing and thickened it. Category: Sport & Outdoors