Apple iPhone 13 Pro Magsafe and Apple Watch Charging Stand

thingiverse

This is a remix of https://www.thingiverse.com/thing:4657117 I realized that the original design would not accommodate the new iPhone 13 Pro, as the new camera protrudes too much to allow for the MagSafe to dock. So I created a little slot to accommodate the camera. I made the slot just a little large to make it easier to line up and get the phone to attach to the MagSafe charger without having to line up perfect every time. Makes it easier to get the phone on and off the charging station. That's the only modification I made. I found that if you print on its side, and your bridging is good, you can get away without any supports. You may still need to add supports in the cable slots to get them to print correctly. I tried it both ways and can make an argument either way. If you don't add supports, you might run into some troubles with the cable slot strength. On the other hand, digging the supports out of those slots was kind of a pain, but the slots turned out stronger. Both ways worked for me. I printed one with 15% infill and one with 20% infill. 20% seemed a little more robust, but 15% works great, too, and will save you approximately 90 minutes of printing, as well as approximately 50 cents worth of filament.