Aperture Science Fan/LED Cover for Hero Me Gen 3 Dual

thingiverse

A remix of mvanallen's "Aperture Fan Cover" tailored for the Hero Me Gen 3 dual fan system, although it may work with other models as well. This design was specifically crafted to accommodate my non-waterproof 8mm LED strip, ensuring that the light shining through the gap between the fan duct and printhead is blocked from reflecting off the front of the duct. However, there remains a shadow directly under the hotend due to the heating block. In contrast, just in front of the printhead receives fairly good illumination. I've included both versions with and without the Aperture Science logo for your convenience. Notably, the version without the logo is simpler to print, so keep that in mind. The slot on the side may be slightly too narrow to slide the strip into comfortably; its primary purpose is to accommodate wire routing out of the side. Instead, you can feed the strip through a small opening in the "shelf" within the slot wall, about a few millimeters wide.