APC Bezel - SMX1500RM2U

thingiverse

This is a variant on Madman1027s design for a similar APC UPS. The SMC1500I bezel did not fit on the SMX1500RM2U in particularly two ways, the display has some ears that widen it which needed to be accounted for, and the case mount clip on the bottom piece didn't fit properly. I adjusted these things so they fit nicely on the different model APC.Additionally, I added a shelf so the insert hex could slot into each half and not require glue, while also leaving with room for a layer of this stuff: https://www.amazon.com/dp/B0BHSS55RM If you don't want to use that, just use Madman1027's original hex insert.Requires (2) M3x20mm screws.Print face down.The hex grid will fit on a 300x300 build plate if you rotate it 45 degrees.Enable tree-supports for a proper print.