Apache_fuse_for_blade_230_s_V2

thingiverse

slice as vase mode, you need lot of glue. some miller, solder and longer cables for tail esc about 16awg and few tinny screws about 1,5M. Plus you need to buy one spare shorter servo horn for rear servo. cut out front mounts of main fraime with inside wide of front fuse P1. rear mounts of main fraime are fit in milling turbines. cut out upper part of front servo holder in main frame. set brim settings for better and stronger tinny vase. parts without tail, set with atleast 3 top layers and 0bottom layers 0 infill 1wall line counts. parts with tail set with 0 top layers and 0 bottom layers 0 infill density 1-2 wall line counts , cut out any walls for less weight like cockpit and tail parts, mill holes in tail motor holder and cut out place for brushless motor. tail prop slice without support with 100 infill. Check this out your adhesion of your bed. 3DLAC is perfect. front land gears slice with support, with 100 infill density