AOS Falcon 7 SMA and GPS Mount

thingiverse

Made for the AOS Falcon 7. This print is designed to hold a TBS SMA extension, a bardpole with ufl connection and a Matek SAM-M8Q GPS Module. The SMA extension is a little difficult to get into the mount. The side for the bardpole is intended to have a little hot glued used on the underside and then I use about one inch of heat shrink around the base of the bardpole on the top side, heat it well so it shrinks down tightly to prevent vibrations. Add a second slightly longer layer of heat shrink if you feel it's nessasery. I haven't decided if it's better to print right side up or upside down. Either way the supports are a little difficult to remove. I trim and tug at the supports with the small flush cut snips that I use for cutting wires.