AOC I2367FH monitor vertical/portrait orientation adapter

thingiverse

This is an adapter to mount an AOC I2367FH monitor vertically (i.e. in portrait mode) as this functionality is not available by default. Simple design that could be refined further if desired, but is fit for purpose in my situation. Depending on the size of your print bed you may need to orient this on a 45 degree angle. I also printed it laying down to minimize the need for supports, but YMMV. I accidentally printed it at only 10% infill and while it functions fine, I would suggest an infill of 20% or higher for longevity. Supports will be required. Printed in about ~8 hours on an Ender 5 at 80mm/s using ~135g of scrap eSun PLA. May require a tiny amount of sanding on the bottom clip that attaches to the monitor base to ensure a flush fit.