Anycubic Wash & Cure Turntable Replacement

thingiverse

The original acrylic turntrable on the Anycubic Wash & Cure apparatus is utterly useless IMO. Small (and even big) objects get pushed to the sides by drag and airflow. As a result, your models fall off the turntable and cause all kinds of unwanted problems. I originally abused half of a Tupperware container to replace the acrylic turntable but it was a) too small and b) it's borderline to install Tupperware into a curing machine. At least as far as I am concerned. So, here is my replacement turntable. I made it larger with a diameter of 15cm/approx. 6,5" and added some rings to prevent (in theory) smaller objects from drifting to the sides. Since the lowest UV-light is mouned quite a bit above the turntable, there is (in my opinion) absolutely no reason to print this in clear PLA. I did just because I wanted to try out the filament. Have fun and stay healthy.