Anycubic Wash & Cure Station Organizer

thingiverse

Hi. Similar to my Creality LD-002R Resin printer (https://www.thingiverse.com/thing:4869807), I wanted to have a cover holder for the Anycubic Wash&Cure station. I wanted to be able to store my cover without further manipulations after the cover holder is installed. In addition, the cover holder should also safely store away the reflector plate and the turn table. Finally, the cover holder including the stored away reflector plate and turn table should be compact enough to allow closing the Wash&Cure station with the IPA tank inside it. The resulting cover holder/organizer consists of two parts, which have to be glued together. I went for two part to allow for easy printing. To prevent bending forces acting on the LED mast, I analyzed the center of gravity of the holder with the Cover installed. As you can see in the pictures, everything should be just fine... Once glued together, the organizer can be easily installed at the top of the Wash&Cure station. Watch out when undoing the screws of the LED front plate of the Wash&Cure: Lay the Wash&Cure down with the LED's facing up. Undo the screws carefully. If you see that any of the LED Covers has moved, place it back with the two little feet inside the little holes on the LED mast. For visualization, check the pictures. Slip the cover holder on top of the LED mast and replace the two top screws with M3x10 (the original screws are too short). To install the reflector plate and the turn table, check the attached pictures. It is really straight forward. Printing: Anything above 25% infill with Gyroid is ok. I used 3 perimeters and PLA. Orient the parts as shown in the photos. These parts does not need support. I designed it with sacrificial layers (check the pictures), which you can cut away easily once the print is done. Enjoy and check out my blog for details (allpro3d.com)!