Anycubic Vyper Dual 5015 Remix for v6 Hotends

thingiverse

This is a remix that adds support for E3D v6 hotends and similar (i.e. Revo Six) The part cooling fan shrouds have been redesigned to have a higher cross-section on the outlet and to fit the new hotend length. Print at least in PETG. If you have one sided part cooling on your machine, turn the part in the slicer to have the air flow at the overhang! For everything else follow the instructions of the original design 4974423. An adapter was designed that allows the mounting of a standard v6 hotend to the Vyper. For assembly you need M2 screws and nuts. The hex slot is tight as there is not a lot of space. If you have problems getting the nut into the hole take a longer screw and pull it in. To mount the adapter to the printer you need two M3 nuts and the original screws. Print the adapter twice on the small flat surface. If you have adhesion issues add some brim. After printing you need to open the 2,2mm holes on the sides with a drill, they are closed to avoid the need for support.