Anycubic Vyper Direct Drive Remix

thingiverse

UPDATE 1/10/2022: Rickyfly has posted a remix (thing:5194434) correcting an alignment issue between the hotend and the extruder. Update 1/3/2022: There's 19.6mm of PTFE tubing which enters the extruder (see photo below). Feed a long piece of ptfe tubing all the way through into your hot end and then mark off 19.6mm sticking out of the extruder bracket. Then cut squarely on the mark. Remix of AndyO7 thing#5110857 Anycubic refreshed the x carriage on the Vyper changing the fan shroud, hot end cable, and shape of the x carriage such that thing#5110857 is no longer compatible. To correct this I made some adjustments; rotating the extruder 90 degrees, increasing the size slightly of the v-slot wheel screw holes, and moving the slot which slips over the tab that sticks up from the x carriage. This remix still uses the all the factory hardware the only thing you need is a longer extruder cable. When installing, remove the blue spacer between the carriage and the hot end wire plug. Cut a length of PTFE tubing to connect the extruder and the hot end. With the direct drive extruder installed you're still able to disconnect the hot end wires.