Anycubic Vyper - Better Spool Holder Arm

thingiverse

Are you annoyed of the bending and twisting spool holder arm, that came with your Vyper? *This spool holder will not bend or twist*. This spool holder clamps on to the printer like the original one. It will also *work with the original spool rest*. You can use this with my custom made spool rest aswell (check them out here: without bearing: https://www.thingiverse.com/thing:4918056 ; with bearing https://www.thingiverse.com/thing:4918052) I made this spool holder reach a bit higher than the original one, so that the spool will sit a bit higher (i don't like it when the filament bends too much). This is the Version with the possibility to use 1 spool, like the original one. If you'd like to have 2 spools sit on your spool holder and/or want to support my work with a small amount, you can check out the "nice to have" Version here: https://cults3d.com/en/3d-model/gadget/anycubic-vyper-better-spool-holder-arm-dolus_eventualis. ---- <h2>HOW TO PRINT</h2> Print this out laying on it's side with supports on. Check in the preview, if the "teeth" in the head are supported. This is important, otherwise the spool rest will not fit. Layer Height: 0.2 Line Width: 0.4 Infill Density: 60% Infill Pattern: Tri-Hexagonal Support Density: 17% I printed with PLA+. ---- <h2>HOW TO DISASSEMBLE (!!!)</h2> Please note, that PLA is not flexing very well. So please don't try to get this out with force. Instead, take the end caps off of the profile you clamped it on and carefully slide it off. Else it may break. ---- Also check out my other designs! Let me know if you have any issues with the file or the print, or have any suggestions to make it better. Thanks for your support!