Anycubic Predator Rod Vice

thingiverse

Replaced the worn rod ends on my delta printer and whipped up this quicky vice/clamp jig for loosening and tightening the ends. Designed for the predator but should work on rods from other deltas too like the Kossel. The hole is tapered to match the end of the rods. To get more clamp pressure just clamp further down. I found the filament alone didn't give enough friction so I just wrapped the rod in a paper towel first and that really helped. Hope this proves useful to you! Bonus: Simple washers you can print to make sure you get your rods back to the same length!