Anycubic Predator E3D V6 Volcano Effector - MagBalls-Remix

thingiverse

Remix of Versus3D E3D-Effector for use with Haydn Huntleys MagBalls. Spacing between ball-centers is 76mm to be compatible with Haydn Huntleys carriage adapters (https://www.thingiverse.com/thing:3880977) Added a small 1.5mm high plateau to make sure air from hotend cooler does exits on the rear completely, not on the lower side. Also enlargened the free space around the heatblock by ~3.5mm - PETG is recommended anyhow. ABS will shrink too much to keep the ball center spacing exact. Edit : Haydns original MagBall Rods will hit the part-blower fan on one side as it lacks ~1mm of clearance tue to the wider rod-ends. If you want to use this design, you need to reduce bed diameter in firmware by 5 to 10mm. Remodeling this for 4010 fans now to avoid this problem. Any help is appreciated :) Ver 0.3 has been uploaded and is currently being printed. Supports are required, manual supports recommended (no supports for hex nut spares and screw holes) Currently being tested !