Anycubic Predator(D) Lerdge X Board

thingiverse

Hello everyone, I'd like to present my upgrade of the Lerdge X Board on my Anycubic Predator(D) 3D printer. First, we'll completely disassemble the old board and keep it for future reference. Next, we can attach the board to two original mounting points, as shown in the photos. Then, we'll connect all cables according to the Lerdge circuit diagram on their website or based on these two images in this post. WARNING: The three fans at the print head share a common mass. We need to disconnect the mass from the hotend cooler and run it up to the board with a new cable. This way, both parts coolers will have their own mass, and the hotend cooler will have its own. NEVER try to bridge the two masses as this will ruin the board! We'll attach the display to the printed frame using small spacers or standoffs to keep it from malfunctioning. Install the TMC2208 modules and pay attention to the correct orientation! Mount a holder for the ninth capacitive sensor (do not use inductive sensors, as they are not recognized by the UB) at the hotend fan with a standoff. I used an M5 nut, as shown in the photos. Next, we'll pull the cable from the sensor up to the board. Make sure it's not too short and the entire travel path is clear. After verifying all connectors and connections are correct, we'll turn on the Predator again and start configuring the printer at the board. You can follow Lerdge's instructions on their website for this step. I won't be sharing my final config of the board here. If you need help, you can join the "German Anycubic Predator Group" on Facebook at https://www.facebook.com/groups/1766177656840834/. I'll be available in that group to answer any questions. Have fun upgrading your printer and good luck! You can find all required parts below, which you should order separately. Note: I am not responsible for any damage to devices. Each person is responsible for their own actions.