Anycubic Photon Mono X protection Bar

cults3d

Based on a bad experience I had, I have created this protection bar for the Anycubic Photon Mono X Axis. I had an accident where I spilled resin, and it ran down the central axis and jammed the stepper motor. I thought it was damaged because it stopped moving. After inspecting and opening the unit, I discovered that it had resin in it and cleaned everything out and now it works like new. But I don't risk it happening again. They have to put double-sided tape at the base of the bar so that the resin, in case of spillage, does not go under the bar. The piece you see printed is not the final one. It is the quick test to make sure it has the measurements and works perfectly. If I have an opportunity I upload photos of the piece in high quality. Important, use double-sided tape to put the piece in place and in case of a resin spill it will not go under.