
Anycubic Photon Mono 4k Z-stop Extension
thingiverse
#Description# This is a longer z-stop flag for the Anycubic Photon Mono 4k with the newer version of the build plate arm which has a curved back where it mounts to the z-axis carriage. This z-stop flag is 4mm longer than the original metal piece, which adds enough space for a magnetic build plate. ##Warning## Improper installation/use of this part can result in the build plate in your printer descending too far and crushing the LCD. Be careful, and test what you're doing before you take actions that might damage your printer. ###Disclaimer### This part is provided with no implied warranty or guarantee, and the creator accepts no liability for any damage caused by its use. #Installation# This is a direct replacement for the original z-stop flag. Before installation, check the printed part for accuracy: verify that it is 49mm long, 19mm wide, and 16mm tall (the flag should extend 14mm above the flat surface of the part). 1. Remove the original z-stop flag from the bottom right side of the z-axis carriage. 2. Install the extended z-stop flag using the original screw. **Test the z-axis home before installing a magnetic build plate!** 3. Re-install the print bed on the printer *without* the magnetic pad. 4. Use the "Home" function (Tools > Move Z > Home) and make sure that your z-axis stops with an appropriate amount of space, or your build plate may crush your LCD. If your print bed leveling screws are loose, the build plate should still sit flat on the LCD even with the extra space (you can level it without the magnetic build plate if you want). 5. Install your magnetic build plate onto the print bed. It's recommended to allow the adhesive on the magnetic pad to cure for at least 48 hours before first use. 6. After curing, re-install the assembled print bed with the magnetic build plate onto the printer. 7. Level the print bed per Anycubic's instructions.
With this file you will be able to print Anycubic Photon Mono 4k Z-stop Extension with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Anycubic Photon Mono 4k Z-stop Extension.