Anycubic Mono X Lid Spacer for Heater Wires

thingiverse

Anycubic Mono X Lid Spacer for Heater Wires <b>PLEASE READ ALL OF THIS</B> <b>01/22/2022</b> - Someone asked for a back left corner cutout, I don't like the way it looks but it should work fine for the people that want it... I think its ugly but its free lol. This is your file: <b>Anycubic Mono X Lid Spacer for Heater Wires - With Back Left Corner Hole</b> <b>01/09/2022</b> - The file for the spacer with the cutout was wrongly names as a test print, it has been updated - if you want to try to keep the door/lid sensor, this is your file: <b>Anycubic Mono X Lid Spacer for Heater Wires -With Sensor Cutout.stl</b> <b>01/06/2022</b> - Added another file with a cutout in the back for the lid/hood/cover sensors (its labeled in the files). It is however untested as I'm using the original "work in progress" version. <b>Please note: This is for the "new" lid that gets smaller at the top than the bottom, like a trapezoid rather than a perfect rectangle.</b> <b>If you are looking for a 4pc version to be printed on a resin printer instead of one large FDM print please see my other design here: https://www.thingiverse.com/thing:5196002 </b> I made this to go with the <b>ANYCUBIC Photon Mono X Clip On Heater Mount </b> [https://www.thingiverse.com/thing:5190198] to feed the wires out. There are other designs however I didn't like the overall feel, I wanted something sturdy. This screws in using the 4 stock holes however the stock screws are too short once added so you'll replace them with <b>four M4x15mm Hex screws.</b> The 4 corners where the screw mounts are 2mm off the build plate so you'll need to have your support and everything dialed in perfectly. <b>I've included a support test file<b/> as well as my print settings for reference The file itself is 290mm x 270mm so you'll need a larger print bed, and no I'm not going to break this into pieces as I feel like that would make the already noxious fume situation worse <b>Note: There is also a "Work in Progress" (beta) design you will loose the safety sensor for the door/hood/canopy. By downloading any of the files on this page, User assumes all risk and responsibility. By downloading User also acknowledges and understands the above and agrees to hold the creator harmless from any and all liability</b> I printed in PETG and here are my settings: Machine: Ender Extender 400x400x500 Nozzle: 0.6 Layer height: 0.48 Line Width: 0.6 Walls: 4 Top/Bottom layers: 5 Infill: Cubic @ 20% Temp 245/80 Cooling 60% Speed - SLOW only 20mm/s Support 70 degree overhang, zig-zag, 0.48 z distance, .06 x/y distance, <b>Enable Support Interface</b>, Support interface thickness 1.92, interface density @ 70%, Pattern Grid Bridge Settings ENABLED <b>Here are my other designs for the Anycubic Mono X 4K</b> ANYCUBIC Photon Mono X Clip On Heater Mount https://www.thingiverse.com/thing:5190198 ANYCUBIC Photon Mono X Z-Axis Bumper Guard http://www.thingiverse.com/thing:5185340 If you do end up using any of these, please take a picture and post a "make"