Anycubic Mega Zero - Casing with xl drawer & mosfet mount

thingiverse

*Introduction** The seen lcd knob is this one [here](https://www.thingiverse.com/thing:5021109). This is an electronics box extension for the [Anycubic Mega Zero](https://www.digitec.ch/de/s1/product/anycubic-mega-zero-3d-drucker-13573014). It has a big drawer and a plate to mount various types of MOSFETs (you just need to adjust the holes). In the future i have plans to design a shorter drawer and a slide-in for the Raspberry Pi. ------------------------------------------------------------------------------------------------------------------------ **Updates** Update 13-10-2021 - rev.0 published ------------------------------------------------------------------------------------------------------------------------ **Instructions** ***Things you need:*** -*12x M3 Screws* -*10x M3 Nuts* -*2x M3 T-slot nuts* -*6x M4 Screws* -*2x M4 Nuts* -*(superglue)* ***Assembly:*** **1.** *Unscrew the bottom piece of your [Anycubic Mega Zero](https://www.digitec.ch/de/s1/product/anycubic-mega-zero-3d-drucker-13573014) control box and unscrew the fan.* **2.** *Screw in the fan with M3 screws and nuts in pull direction (inside->outside) on the back of "top-half" so that cable of the fan exits to the top.* **3.** *Assemble the "bottom-half" and your MOSFET with M3 screws and nuts.* **4.** *Screw in the "bottom-half" to the "top-half" with M3 screws and nuts.* **5.** *Connect your cables.* **6.** *Screw the "top-half" + "bottom-half" to the Mega Zero control box with M4 screws.* **7.** *(Glue the feet's to the drawer), slide the drawer in.* **8.** *Screw the "mount-front" and "mount-rear" on the top of the t-slot rail next to your control box, mount your control box to them.* ------------------------------------------------------------------------------------------------------------------------ *I'm open for requests and comments, much fun printing!*